Pickled Jalapeño Rings
- 3 pounds jalapeño peppers
- 1½ cups pickling lime
- 1½ gallons water
- 7½ cups cider vinegar (5%)
- 1¾ cups water
- 2½ tablespoons canning salt
- 3 tablespoons celery seed
- 6 tablespoons mustard seed
1.
|
Wash peppers well and slice into ¼"
thick slices (a mandolin slicer works well). Discard stem end. Mix 1½ cups
pickling lime with 1½ gallons water in a stainless steel, glass or food grade
plastic container. Avoid inhaling lime dust while mixing the lime-water
solution. Soak pepper slices in the lime water, in refrigerator, for 18
hours, stirring occasionally (12 to 24 hours may be used).
|
|
2.
|
Drain lime solution from soaked pepper
rings. Rinse peppers gently but thoroughly with water. Cover pepper rings with
fresh cold water and soak, in refrigerator, 1 hour. Drain water from peppers.
|
|
3.
|
Repeat the rinsing, soaking and draining
steps two more times. Drain thoroughly at the end.
|
|
4.
|
Wash and rinse pint canning jars; keep hot
until ready to use. Prepare lids according to manufacturer's directions.
|
|
5.
|
Place 1 tablespoon mustard seed and 1½
teaspoons celery seed in the bottom of each clean, hot pint jar. Pack drained
pepper rings into the jars, leaving ½-inch headspace.
|
|
6.
|
Bring cider vinegar, 1¾ cups water and
canning salt to a boil over high heat. Ladle boiling hot brine solution over
pepper rings in jars, leaving ½-inch headspace. Make sure pepper rings are
covered with brine.
|
|
7.
|
Remove air bubbles and adjust headspace if
needed. Wipe rims of jars with a dampened, clean paper towel; apply two-piece
metal canning lids.
|
|
8.
|
Process in a boiling water canner according to the
recommendations in Table 1. Let cool, undisturbed, 12 to
24 hours and check for seals.
|
Process Time at
Altitudes of
|
||||
Style of Pack
|
Jar Size
|
0 - 1,000 ft
|
1,001 - 6,000 ft
|
Above 6,000 ft
|
Raw
|
Pints
|
10 min
|
15
|
20
|
.gif)
No comments:
Post a Comment